HORNADY - Hornady Cam-Lock Bullet Puller

Quick to set up and adjust. Fast tool to pull down loaded cartridges.

Once you figure out a reliable way to only raise the bullet into the arbor and not the case, it works great. I wish Hornady would sell the arbors in a complete set Otherwise I would recommend this puller to everyone.

After reading other reviews I purchased this to use with my Forster CoAx press. Hornady's Cam Lock Bullet Puller worked perfectly for my needs. The collet gripped the bullet, barely leaving a mark at all. A casual observer would be none the wiser. I recommend this tool to any reloader.

after getting this properly adjusted through youtube vids as i did not find the provided instructions helpful, the puller worked great. i was able to pull .38 special swc bullets with almost no marks left on the bullets. this is great if you have a large quantity of bullets to pull otherwise the "hammer" works satisfactory.

If you remove bullets from couple dozens ammo then this is the right tool for you. The kinetic hammer may take couple minutes and lot of bouncing and effort to remove one bullet. After the set up, this cam-lock can remove 1 bullet in 10 sec without effort. I used it on Lee Turret press, I mount it on the turret plate, to set up instead of set up the way Lee's video shown (too complicated) I just turn the turret plate up side down then adjust with my eye that when I pull the handle down the collet can grab the bullet, then whole set up took less than a minute.