MARK II SAFETY

MARK II SAFETY Reviews & Ratings

Graceful design sets low, allowing lowest possible scope mounting. One-piece construction, beautiful, non- glare, blued finish. Right-hand operation only. Easily installed, requiring slotting of bolt sleeve. SPECS: ?' (19mm) long arm, 3/16' (4.8mm) wide. Blued steel.
View Product
Write a review
Reviews Summary
The MARK II SAFETY product receives mixed feedback. Customers appreciate its affordability and functionality after installation, but many note that it requires significant modification and lacks clear instructions. Concerns about product quality and safety reliability are also highlighted, especially regarding the use of cheap materials and designs prone to failure.
What Reviewers Are Saying
Installation Difficulty
70%
Many reviewers express that installing the MARK II SAFETY requires significant alterations to the rifle and can be quite challenging. The necessity for precision in modifications, such as grinding and cutting, is often emphasized, with several users recommending professional gunsmith assistance for optimal results.
Product Quality
65%
There are numerous complaints regarding the overall quality of the safety. Reviewers note poor finish details, the presence of casting marks, and the use of potentially unreliable materials, which raise concerns about durability and long-term functionality.
Instructions and Guidance
60%
The provided installation instructions are frequently criticized for being unclear or inadequate. Many users report needing to figure out the installation process through trial and error rather than relying on the manual, leading to frustration during the setup.
Value for Money
50%
Despite its drawbacks, several customers feel that the MARK II SAFETY offers good value for its price. Its affordability is often highlighted, with some users noting that it is difficult to find similar products at a lower cost, even if it may require significant work to install.
Safety Functionality
55%
Reviewers report mixed experiences regarding the safety's effectiveness. While some users find it works satisfactorily, others express concerns about its reliability, especially matters related to locking mechanisms and potential safety failures during operation.
3
Okay
It requires machine work whichi was ot counting on.
3
difficult to rate
I'm quite fortunate to have a knee mill and a 1/8" carbide endmill.....yes this safety can be installed with a dremel tool and a cutoff wheel but it's far better done with a mill. The directions were ambiguous but after a bit of study it was clear what needed to be done....I'd rate the directions as poor....but it did get me through the process. The safety works well but does not lock the bolt.....be your own judge on that one. IMO it should be installed by a competent gunsmith
3
Slotting can be a problem
You need to slot the bolt sleeve for this safety to work. The problem comes from installing on M-96 Swedish Mausers which have very hard and brittle steel (high nickel content). After slotting (which is best done with a Dremmel cut-off wheel - most files will not cut the steel used on these guns), you will have a narrow ear left to hold the safety in place when the gun is cocked. It can break off allowing the safety to come back and keep the gun from functioning. Welding this ear back on and finishing is a chore. This may not be a problem on other small ring Mausers though. Safety works okay though.