MARK II SAFETY

MARK II SAFETY Reviews & Ratings

Graceful design sets low, allowing lowest possible scope mounting. One-piece construction, beautiful, non- glare, blued finish. Right-hand operation only. Easily installed, requiring slotting of bolt sleeve. SPECS: ?' (19mm) long arm, 3/16' (4.8mm) wide. Blued steel.
View Product
Write a review
Reviews Summary
The MARK II SAFETY product receives mixed feedback. Customers appreciate its affordability and functionality after installation, but many note that it requires significant modification and lacks clear instructions. Concerns about product quality and safety reliability are also highlighted, especially regarding the use of cheap materials and designs prone to failure.
What Reviewers Are Saying
Installation Difficulty
70%
Many reviewers express that installing the MARK II SAFETY requires significant alterations to the rifle and can be quite challenging. The necessity for precision in modifications, such as grinding and cutting, is often emphasized, with several users recommending professional gunsmith assistance for optimal results.
Product Quality
65%
There are numerous complaints regarding the overall quality of the safety. Reviewers note poor finish details, the presence of casting marks, and the use of potentially unreliable materials, which raise concerns about durability and long-term functionality.
Instructions and Guidance
60%
The provided installation instructions are frequently criticized for being unclear or inadequate. Many users report needing to figure out the installation process through trial and error rather than relying on the manual, leading to frustration during the setup.
Value for Money
50%
Despite its drawbacks, several customers feel that the MARK II SAFETY offers good value for its price. Its affordability is often highlighted, with some users noting that it is difficult to find similar products at a lower cost, even if it may require significant work to install.
Safety Functionality
55%
Reviewers report mixed experiences regarding the safety's effectiveness. While some users find it works satisfactorily, others express concerns about its reliability, especially matters related to locking mechanisms and potential safety failures during operation.
4
Good for the money
I recently installed 4 of these on some small ring commercial Husqvarna actions from the 30s and 40s. The bolt does lock down when the safety is engaged. Yes the finish is not the best but you will look long and hard to find a safety this inexpensive. Yes the good ol days are over but the do polish up easily. I prefer these over the Timney because there is no screw holding the 2 pieces together. That screw will go bye bye when you need it the most.
4
Mark II Safety M98
I have installed several of these safetys now and find them to be reliable. I don't care for the trigger safety on custom sporters (I guess I am old school that Way). The most difficult part of the installation is of course the grinding of the shroud. I had mine done in only 20 minutes using a dremel and cut off wheel. The principal when grinding is slow and steady. Don't try to hog out the metal in one or two cuts. Take your time and FIT the safety to the shroud. As far as the teflon tension piece is concerened; it is the weak link with this safety. I have played with the idea of drilling out the teflon tension hole on the safety and trying out a spring and ball setup. When I do I will let you know. Finish is flat, something I wish they would make in a high polish blue. As far as a safety goes though, I like it. It is definately more fashionable than the timneys; which I have also installed and twisted the soft screw heads off of.
4
Mark II safety
I agree on the finish details but the safety will work OK if it is properly installed. It works the same as you would on a 98 Mauser.They must be timed with the sear or you will have a condition as you described.