BURRIS - 1" AR-PEPR Mount

Mounted a Vortex 3x9x56 Vortex Hog Scope on AR500 Auto Max Rail For Heavy Recoil,. I will use on 300 RUM For the Heavy Recoil. Scope is secure and does not loose zero when I remove or change to a different scope, I have several of these Burris 30mm mounts, all are very good. and soliid, Seem to be inline with bore. This is a 0 moa mount. I use a mounted green laser to bore sight the rifle, then bore sight the Cross Hair Retical,. A few minor Up&Down adjustments to the green dot. Then Its To the Range To Fine Tune The Bulls Eye shots. Price is lowest found from Brownells. I'm an EDGE member, so I save a few $ on Shipping. I will buy more It is a Good Solid Mount.

This AR-PEPR placed upon an AR15 flat top, makes a very solid mount. Utilized was a 4-16X42 variable power scope. I like the option of a smooth or tactical ring top, and appreciate the mount and rings in one unit. Very nice mount!

First of all, this is not my favorite AR 15 scope mount. I gave it 5 stars though for the following reasons. 1) It is well built. 6 screws per ring and the screws are long and seem very well made. 2) I love how it has the tactical Picatinny ring cap but also includes the smooth tops. I went with smooth this time, so I have included a picture. 3) I consider this mount to be a "best buy" even though it is not the best out there. My favorite mounts cost 30-115% more. I think that the mount is built more for tactical use and really designed more for tactical, low power scopes with an objective lens the same size as the tube. For scopes with a larger objective lens or large knobs, the space between the rings is a little bit too tight... But it works! I have seen some guys complain because they are "made in China." While not my preference, they do seem well made. I bought a couple of cheap Chinese mounts that look similar to mount on some .22 lr AR 15 rifles that I have. I had screws that stripped and the metallurgy was just not right. These on the other hand may be Chinese, but they are very well made.

I have several AR 15 rifles. This mount has been my favorite by far. The height is perfect, the mount seems to be very well made and the cantilever puts the eye relief right in the sweet spot. I am getting ready to order my third.

I purchased a 1" and a 30mm dia. Burris PEPR scope mount to accommodate a Burris and Vortex scope for my AR rifles. Both scope mounts fit perfectly and I was able to sight in within 4-5 shots. The Burris scope mount also allowed me to install a Caldwell brass catcher base mount just before the charge handle (back end of upper receiver Picatinny rail). With 6 screws per ring (12 screws total) I doubt this will ever come loose. The height of the mount is perfect for mounting a scope on a AR format rifle.