Brownells 75th Anniversary - A Shooting Heritage

60\ & 65\ Shoulder x .330"

Our special 65° shoulder Sight Base Cutter designed to cut dovetails for both standard Colt factory and mil-spec 1911 Autos, and for replacement sights like Wichita Hi-Mount, older Bo- Mar and others with a 65° shoulder. Some makers use a 60° dovetail on their rear sights and we also have a cutter to match them. For low-mount adjustable sights use the Standard Sight Base Cutter shown on this page. Actual cutting diameter is .330" so more than one pass will be required to install most sights. This is done on purpose to allow for factory variations in base width as well as milling tolerances. CAUTION: For use in milling machine only. High speed steel, 2" (5cm) long, 3⁄8" (9.5mm) diameter shank. 60° or 65° shoulder. DO NOT EXCEED 700 rpm, HIGHER SPEED WILL BREAK TEETH.

1911, Issue:01, Page:051
1911, Issue:02, Page:051
1911, Issue:03, Page:056
1911, Issue:04, Page:056
1911, Issue:05, Page:056
1911, Issue:06, Page:057
1911, Issue:07, Page:056
1911, Issue:08, Page:056
1911, Issue:09, Page:061
1911, Issue:10, Page:063
1911, Issue:11, Page:061
Big Book Catalog, Issue:49, Page:123
Big Book Catalog, Issue:50, Page:131
Big Book Catalog, Issue:51, Page:140
Big Book Catalog, Issue:52, Page:136
Big Book Catalog, Issue:53, Page:142
Big Book Catalog, Issue:54, Page:142
Big Book Catalog, Issue:55, Page:143
Big Book Catalog, Issue:56, Page:150
Big Book Catalog, Issue:57, Page:166
Big Book Catalog, Issue:58, Page:169
Big Book Catalog, Issue:58, Page:305
Big Book Catalog, Issue:59, Page:171
Big Book Catalog, Issue:59, Page:311
Big Book Catalog, Issue:60, Page:048
Big Book Catalog, Issue:60, Page:205
Big Book Catalog, Issue:60, Page:3


narrow your choices »
Show Filters
2 Item(s)

Filtered Matches

Other Matches