WHEELER ENGINEERING - Armorers Handgun Sight Tool

The tool is very well made and works great. The printed instructions are easy to follow. I highly recommend this product.

This Wheeler sight adjusting tool worked great on my 1911 and other Pistols.

I opened the box, read the instructions, oiled all the threaded surfaces and ran these as far in and out as travel allowed. I cut three small pieces of card stock for each slide of the slide and a third for the top of the slide for protection from hold down. I moved the slide hold down to the lowest position. I centered the H shaped push block and set the side between the paired centering locks with two of my card stocks in place. I tightened one side and checked reference grooves in base for straightness. And tightened these into position. I set the top into place and positioned my third piece of cardstock. I lightly turned the knurled nuts down. I then checked clearance of the push block relative to the top of the slide and the bottom of the “H” pusher block legs. I allowed about .062” clearance here adjusting the hold down block to set this gap and tighten the knurled nuts. I made a small pencil mark on the left and right side of the sight blade onto the tip of the slide. I put a drop of oil on my sight and began turning the X handle. The front sight moved easily. This was on a Kimber 1911 that was factory inserted with a hydraulic pusher. This is an impressive tool. I called Wheeler and thanked them for a nicely made tool.

I have a NcStar Universal Pistol Rear Sight Tool. The only pistol, in my inventory, that it worked with is a Colt Double Eagle. It definitely was not going to work with my HK P30. The Armorers Handgun Sight Tool worked perfectly. I had no issues with the P30 front and rear sights. This sight tool holds the slide better. Will accommodate more makes and models. It's very simple to use. So easy instructions aren't needed. I definitely recommend.

I’m an OCD freak and a gun snob.I usually don’t even look at wheeler products, but a buddy of mine told me to check it out, so I ordered one instead of ordering the MGW brand. I wanted one to replace sights here and there and to adjust the sights on the pistols I have that aren’t dead on . I hate to aim at something and the point of impact be off. When the tool showed up I was very pleased with the quality and ease of use…..it’s built just as heavy duty as the MGW brand tool. VERY HAPPY!