RIFLE CASE HOLDERS

RIFLE CASE HOLDERS Reviews & Ratings

L.E. WILSON RIFLE CASE HOLDERS

The L.E. Wilson Rifle Case Holder holds the case for trimming, primer pocket reaming, neck reaming and deburring. The L.E. Wilson Trimmer Case Holder provides the ultimate accuracy and uniformity for trimming your cases. The unique design of the case holder supports the case body, much like a chamber of a firearm. The Case Holders are precisely manufactured for consistent results and repeatability.

The FIRED Case Holders are for Neck Sized Cases. NEW Case Holders work with new, unfired brass or cases that have been full length sized. If a type isn’t specified the holder will fit both Fired, New, Neck or Full Length sized cases.

View Product
Write a review
Reviews Summary
Customers praise the L.E. Wilson rifle case holders for their precision and compatibility with the Wilson trimmer, making them essential for accurate reloading. However, some issues arise with case fit for specific calibers, leading to frustration, particularly with .308 and some resized brass. Overall, the quality and performance often outweigh the challenges experienced.
What Reviewers Are Saying
Product Quality
75%
Reviewers consistently highlight the superior quality of L.E. Wilson products, noting their precision and sturdiness, which have solidified customer loyalty over time. Many mention that these holders work flawlessly with the Wilson trimmer, delivering accurate trimming results.
Fit and Compatibility
60%
Some users experienced issues with specific calibers, particularly with .308 cases not fitting properly in the holders. It's noted that accuracy may be affected based on the brass type and condition, indicating the importance of choosing the correct holders for new versus fired brass.
Service and Support
50%
Several reviews commend Brownells' customer service, particularly in addressing fit issues. L.E. Wilson’s willingness to assist customers, even offering to alter holders at no cost, reflects well on their commitment to customer satisfaction.
User Experience and Ease of Use
55%
Many users enjoy the overall experience of using the case holders, mentioning ease of use and the effective results achieved when trimming cases. However, some concerns about snug fits leading to difficulty in removing cases post-trim were noted.
Precision and Accuracy
70%
A recurring theme is the precise trimming capabilities of the Wilson system, with users reporting consistent results down to thousandths of an inch. This precision makes it highly regarded among serious reloaders who seek accuracy in their ammunition.
4
Does Not Work With Hornady Dies
Recently bought this case holder to use after full-length resizing with Hornady New Dimension Custom Grade K-31-specific 7.5x55 Swiss dies. Case mouths would not exit the holder, making trimming impossible. However, I measured the shoulder on the resized brass and a fresh GP-11 cartridge. The GP 11 measured .448." The "resized" brass measured .472." I think the blame clearly lies with Hornady's dies, not the Wilson trimmer. Nevertheless, I am leaving this review because I want other shoppers to be aware that if they plan to use the Hornady dies, they will need to buy the trimmer holder for FIRED cases, Wilson item CH7555.
4
Can be upgraded for Lapua Brass
You may be able to alter this Holder slightly to avoid having to also buy a New 204 Brass Holder. New Lapua Brass sits too deep inside this Holder, so that the Case Length Trimmer's threaded Adjustment Stop can't reach the case head. But by using a drill press, you can widen the back end of this Holder's hole so that the Adjustment Stop could enter the hole and reach the New Brass case heads. I didn't need to drill very deep, just about 0.1". I used a bit that was a little wider than the Adjustment Stop's face. I don't know if this will work for Norma brass, as I only use Lapua brass.