RIFLE CASE HOLDERS

RIFLE CASE HOLDERS Reviews & Ratings

L.E. WILSON RIFLE CASE HOLDERS

The L.E. Wilson Rifle Case Holder holds the case for trimming, primer pocket reaming, neck reaming and deburring. The L.E. Wilson Trimmer Case Holder provides the ultimate accuracy and uniformity for trimming your cases. The unique design of the case holder supports the case body, much like a chamber of a firearm. The Case Holders are precisely manufactured for consistent results and repeatability.

The FIRED Case Holders are for Neck Sized Cases. NEW Case Holders work with new, unfired brass or cases that have been full length sized. If a type isn’t specified the holder will fit both Fired, New, Neck or Full Length sized cases.

View Product
Write a review
Reviews Summary
Customers praise the L.E. Wilson rifle case holders for their precision and compatibility with the Wilson trimmer, making them essential for accurate reloading. However, some issues arise with case fit for specific calibers, leading to frustration, particularly with .308 and some resized brass. Overall, the quality and performance often outweigh the challenges experienced.
What Reviewers Are Saying
Product Quality
75%
Reviewers consistently highlight the superior quality of L.E. Wilson products, noting their precision and sturdiness, which have solidified customer loyalty over time. Many mention that these holders work flawlessly with the Wilson trimmer, delivering accurate trimming results.
Fit and Compatibility
60%
Some users experienced issues with specific calibers, particularly with .308 cases not fitting properly in the holders. It's noted that accuracy may be affected based on the brass type and condition, indicating the importance of choosing the correct holders for new versus fired brass.
Service and Support
50%
Several reviews commend Brownells' customer service, particularly in addressing fit issues. L.E. Wilson’s willingness to assist customers, even offering to alter holders at no cost, reflects well on their commitment to customer satisfaction.
User Experience and Ease of Use
55%
Many users enjoy the overall experience of using the case holders, mentioning ease of use and the effective results achieved when trimming cases. However, some concerns about snug fits leading to difficulty in removing cases post-trim were noted.
Precision and Accuracy
70%
A recurring theme is the precise trimming capabilities of the Wilson system, with users reporting consistent results down to thousandths of an inch. This precision makes it highly regarded among serious reloaders who seek accuracy in their ammunition.
3
Limited use with fully sized 308 cases
Let me say, first, that Wilson products and services are top notch, as is Brownells service. (Wilson trimmers are the most accurate I've ever used. I've trimmed hundreds of rifle cases in various calibers.) This particular case holder works for 243 fully sized (new) and fired brass. It does not work with once fired Lake City or Federal fully sized 308 brass. I used two different Redding presses and standard FL sizing Redding and RCBS dies to check this holder. The sized cases would not extend far enough to be trimmed. I do not have small base dies which reduce the case size to a greater degree to allow more efficient chambering in semi-automatic rifles. I did not use factory new, unfired brass. Based on what I've experienced, I would recommend BOTH case holders to prospective buyers. Rifle chambers vary from Target to Hunting to Military. This is not the fault of the manufacturer or the vendor.
3
nothing special
soft material,dents easily when dropped to the concrete floor.
3
You may not need one of these.
You may not need to buy this New Brass Holder, if you buy the standard Holder (for fired brass) and alter it slightly. New Lapua Brass sits too deep inside the standard Holder, so that the Case Length Trimmer's threaded Adjustment Stop can't reach the case head. Using my drill press, I widened the back end of the Holder's hole so that the Adjustment Stop could enter the hole and reach the new brass case heads. I didn't need to drill very deep, just about 0.1". I used a bit that was a little wider than the Adjustment Stop's head. I don't know if this will work for Norma brass, as I only use Lapua brass.