Best for hardball
This recoil spring hits the balance point perfectly. Ejection is consistent at about 8 feet from the gun. Using 2 of the faster hardball loads of 230 grains at 860 + fps. More moderate loads at 825 fps still function well, though ejection is closer to 6 feet.
Would you recommend this?
Yes, I would recommend to a friend
Wilson flat wire guide rod
Very well made, will buy again
1911 recoil springs
Good service on the parts I needed, at a good price.
Spring is Coming
Great products at great prices, as well as fast delivery.
Problem Solver
I picked up Remington 1911-R1 Enhanced about 4 years ago only because it actually had good fit and finish and a really decent trigger pull. Rest of the my 1911 collection is split equally between a dozen Colt/Springfield. It rode the safe for 3 years until I finally decided to run a 100 hundred rounds through it. The first trip out was met with FTF problems, I swapped from Remington to Wilson magazines and observed the same issue. I trolled the forums and saw a number of complaints of FTF, FTE problems with the 1911-R1 and the associated fixes, polish feed ramp, tune extractor, magazines, barrel bushing, etc. it was like reliving my first experience with the old rattling war relics and 1970s Colt production. Now I could have just sent the pistol back for warranty repair and in the past I have experienced excellent customer service with Remington but, considering the holidays, pandemic and general climate of the country I decided to grab a couple of Wolff recoil springs. Problem Solved! The gun runs flawlessly. The pistol probably would have been fine after 500 plus round break-in period but, with todays price of ammo it was much more economical to just increase the spring rate from 16.5 to 17.5 lb. Stick to the the simple fixes first!
Good 1911 recoil spring, usual Wolff qua
Went in as usual, restored correct operation of a pistol.
Recoil spring
Installed in my Remington 1911 R1 to replace the factory spring. It seems a bit stronger too, I suspected the stock spring wasn't that good. No more failure to go into battery issues!
Very Good Replacement Set.
On a Colt Series 70 Govt Model, Mark IV. that may not have been DCOA'd since the 70's among the problems were a bent recoil spring, and a broken firing pin return spring. This kit fit perfectly. The owner was pleased and noted no changes in recoil management.
Recoil springs
Easy to install Wanted good spring for shooting No problems in shooting 5 different loads .Ordered 2 more springs for spares
Good replacement part
This is one of the first upgrades I buy for a government model 1911. I ditch the factory spring and opt for the 18.5 lb. recoil spring to shoot FMJ 230 loads.
