Fail to eject
Solved my problem. Works well.
Excellent Part!
Fit like OEM a great upgrade to my Ruger products!
Happy Customer
Arrived fairly quickly and works well.
Yup, it worked
My son had trouble with the custom 10-22 I built him. Fail to ejects like you wouldn't believe. I tore into it only to find a damaged extractor claw. Bought a pair of Exact Edge Extractor by VOLQUARTSEN and installed one in his rifle. Range test, one fail to feed, zero fail to extract out of 200 rounds.
Good product
I purchased two of these to upgrade older 10/22s. This is clearly a better made part than the factory original. It is sharper and better machined. It definitely grabs the case better than the original part did, even with my recut extractor groove in the barrel. This is probably the first part I will put in every 10/22 I work on.
Volquartsen exact edge extractor
Easy to install, typical Volquartsen product, works perfect
Small Part, Good Results
The Exact Edge Extractor is sharper and a bit longer. Easy to install and well worth the effort.
Quick and simole
The installation was easy. I used a video I found on YouTube. I compared the stock extractor to this one and there are slight differences. After install, I fired 50 rounds through my rifle and everything worked fine. I would recommend.
No Malfunctions During Last Outing!
After receiving a Ruger Mark III Target for a gift in 2009 I left it stock for nearly a decade. It has accounted for a few different species of animals as well as paper and steel targets. During the past few years there seemed to be an increase in the number of malfunctions - failures to extract or eject the brass. After ordering and receiving the Volquartsen Exact Edge Extractor I installed it myself with a referral to some of the online videos detailing the steps. It is a little more time consuming getting the old extractor out than getting the Volquartsen extractor in but not too bad. I followed the instructions on the box which suggested using the Ruger extractor spring when installing the Volquartsen extractor on the Mark series pistols. My first outing to fire the Mark III after the Volquartsen extractor install was a brief 100 rounds in fairly rapid succession. I fired 50 rounds of CCI MiniMags and 50 rounds of low cost Federal ammunition (the modern equivalent of the old Federal Lightning). The pistol had no malfunctions of any kind! It has been a long time since that happened. I firmly believe this Volquartsen Exact Edge Extractor has vastly improved the reliability of this pistol.
Flawless
This simple upgrade made all of the difference. I recently upgraded the stock barrel and after making the switch I experienced numerous FTEs. Before trying more extreme options I tried this simple upgrade. Turns out this $12 part was all I neede. Just put a few hundred rounds through it without a single issue. Nothing gets past this claw!
