Excellent quality
Very consistent results with high quality manufacturing. . Also bought the seating die which is the most consistent I've used
Would you recommend this?
Yes, I would recommend to a friend
LE Wilson 6POC Factory FL Die
Another quality product from a first rate dealer. Quick shipping!
Would you recommend this?
Yes, I would recommend to a friend
Great die set
Typical Wilson quality. Excellent quality. Fit and finish is great and no issues with set up.
I'll give it 5 starts for finishing
Was hoping it would hold runout on the cases better than the others. Not so, so far but have been using Redding bushings. Have ordered Wilson bushings they say will solve my problem. We shall see.
L.E. Wilson 6mm ARC Bushing Sizing Die
L.E. Wilson bushing type sizing dies are precise tools. I like these dies because you can experiment with the neck diameter to find the neck tension that gives you the best shot groups. I've been using this die to reform 6.5 Grendel brass to 6mm ARC. It does this job perfectly!
Quality
Very well made, easy to use, should not have to worry about rust over time. I have .262 neck full sizes and does the neck all at once,Great product.
Excellent LE Wilson product.
Easy to use, no fuss, and very well made.
Beautifully made...but....
This is a beautiful die, very well made however, for applications using the Dillon 550B press, there is not enough die thread to allow the die to be turned down to touch the shell plate and have enough threads left to install the lock nut. There needs to be about 1/4" more thread. I contacted Wilson and they understand the problem...future runs can easily resolve the problem but as machined, they will not work on the Dillon 550 series presses... Manufacturing oversite. Otherwise, nicely made...but no expander ball assy available as yet, just the decapping rod.
Good die...no expander available..
Good quality die...but a problem if you plan to use this die for Semi Auto case preparation. L.E. Wilson failed to consider this application though they make their bushing die in cartridges often used in semi auto's. There is no expander spindle assembly available as yet which means, if you have cases with dented case mouths, you may not be able to iron out those dented mouths which then is a problem for bullet seating after sizing. Talked with L.E. Wilson and they indicated they may have spindles available in a month or so....but nothing yet.
