Daily Deal: Eylar 250th Celebration Rifle Case ~~$259.99~~ $169.99 - Get Yours!

BARREL CROWNING LATHE BIT Reviews & Ratings

A difficult tool to grind correctly. These are expertly done to give maximum cutter strength and proper clearance as cutter tip enters bore and shank approaches barrel. By taking careful cuts and moving table back and forth, any degree of crown shape can be cut.

View Product

Write a review

3 Stars

1 Stars

Sort by Filter by rating

Not Ready to Use

When I spend this much on a bit I expect it to come ready to use out of the box. As it comes you need to grind away part of the tool as it scraps the side of the barrel before the cutting part does. Maybe if your doing .50 this would work without modification but for smaller calibers it does not. Might as well save money and buy a blank lathe bit and grind your own.

Not as shown

Mine was only ground on one side. One of the selling points was two sided grind. Would have never ordered if I had known that but since I have it I will use it.