Gets the Job Done
Bought this to replace the flat trigger in a Dan Wesson TCP. It dropped right in without any fitting (this trigger was .01" smaller than the factory trigger), which is not my preference for 1911 parts (I'd rather they be slightly oversized and fit them, but that's just me). This results in a slight amount of up-and-down play which again, I would have preferred to have control over, but even my Wilson Combat 1911 has up-and-down play in the trigger, so that's just a nit-picky thing.
The minus 1 star is because the overtravel adjustment screw stripped out with the included wrench. I had to back it nearly all the way out for it to fit, and fortunately, where it stripped is where I wanted it, so it was purely a stroke of luck. I don't see how adjusting it to that point could have been avoided.
When installed though, the trigger feels nice, seems to be well finished, and other adjustments otherwise went smoothly. I'd say this is fairly priced, and if you fancy the look, then there's no reason not to get it. Otherwise, go for a Wilson, EGW, Harrison, or 10-8 and don't look back.
Would you recommend this?
Yes, I would recommend to a friend
Nice looking trigger & easy to install
I'm only giving it 4 stars as the edges of the bow were rough and the bow was not straight with the trigger. After straightening the bow and stoning off the sharp edges, it fit perfectly and moved smoothly - now it's a 5. Adjusting the "wings" to set/limit trigger take up was easy as well as setting the over travel screw.