A MUST FOR AR-15 SHOOTERS
IF YOU BREAK THE BACK OFF A SHELL IN YOUR GUN YOUR IN TROUBLE. DONT TRY AND PUSH IT OUT WITH A CLEANING ROD, YOU COULD SCRATCH THE BORE. USE ONE OF THESE EXTRACTORS, JUST PUT IT IN THE RECEIVER LIKE YOU WOULD A LOADED ROUND AND EJECT THE BROKEN CASE. EVERY AR SHOOTER SHOULD HAVE ONE IN THERE KIT.
Didn’t work
Completely failed to extract case. Worthless.
Broken Steel Case in AR-15
I purchased this tool to remove a steel case that was broken and stuck in the chamber of an AR-15. I read and followed the instructions that were included with the tool. Unfortunately, the tool fails to hold onto the mouth of the case long enough to extract the case. I spread the end of the tool evenly to the maximum diameter that would fit down the bore. The tip of the tool ends up compressing and sliding out the back of the case. I want to like this tool, but I guess it isn't going to work for this application. I will keep it on hand in case I ever have this issue with a brass case.
Doesnt work
Had zero affect on the broken shell. Waste of money.
Don't waste your money.
Don't waste your money. Totally useless for LR308.
Didn’t work
No-go
It doesn’t work.
It doesn’t work in a 308 chamber. Over 20 years building target, hunting, and tactical bolt action rifles and this product doesn’t work.
Not strong enough
I had the rear .560 rip off of a case in the chamber of my AR. I tried using it as instructed but the tool would just shove all the way into the chamber and wouldnt seat in the bolt face. I then hooked the rim of the tool in the extractor and seated it in the bolt by hand and let the bolt go forward. The tool did go through the case and catch on the neck but after some force, the teeth slipped before the case came out. This happened several times and still no progress. If your case is really stuck in there, this wont help you. Two thumbs down on this thing
failed to remove case.
Well made.The shell in my rifle was stuck too tightly and the tool did not remove it. I removed the stuck case using Cerrosafe. I wish I would have tried the Cerrosafe method first and saved myself the money I wasted on the tool.
Waste of time
I bought this to try and remove a broken shell from an ar-15 barrel. No matter how I adjusted it or anything the extractor would always seat itself in the chamber where the gun extractor would not grab it.
