J P ENTERPRISES - Small Anti-Walk Pins

If you are going to run a drop-in trigger system, an anti-walk pin set is a must. I do not like using the set screw that some of the drop-in triggers have, they aren't the best option. I have used this pin set on most of my builds.

Great product that does exactly what it’s supposed to do… effectively, efficiently, and economically. Simply put, these pins have everything you need, nothing you don’t!

Fast shipping, everything as described. Thank you.

I headlined thus with the torx bit size (#8) for two reasons. First, somewhere I saw listed hex head, but these are definitely torx, T-8 specifically. Also, you will need two different bits, one for each side (obviously). On to quality. They are good. I found mine to be a bit too long; the pin stuck put slightly on each side. It was probably just enough to slide a piece of paper under the head of the screw, but I could see where some might find that too much. I think the length is to accomodate different receivers, especially bullet. I would buy again.

Easy to install and work perfectly.