TACTICAL SOLUTIONS, LLC - Threaded Fluted Barrel, MB

Steel Challenge shooter - have easily 25,000+ rounds through this XRing barrel. Still shoots great - accurate and light. Have it mounted to a factory Ruger receiver and now run a Volquartsen bolt. Zero issues with feeding as long as it is fairly clean. Yesterday, over 500 rounds in the session - one fail to feed - cleaned it up and good to go... I will say that the breach face has a noticeable indent where the bolt hits it. For a rough comparison, I have another full Volquartsen barrel, receiver and bolt set - has about 8,000 rounds total through it. Yesterday training, 500+ as well. The Volquartsen barrel tends to lead up a bit - the XRing seems to lead less. I shoot both rifles in competitions. Almost never have an issue as long as you use quality ammo and good mags - BX10 or DoubleKross.

This is the best overall light weight 10/22 barrel I have used 4 of these so far and really like them. This barrel in a Hogue overmold stock and a BX trigger changes your 10/22 to a light fast hunting rifle. add Talley rings and a good 2-7 rimfire scope to complete it I have noticed the newer 10/22 actions are tighter fitting than the older models so you do need to sand a little. I also cool the barrel in the freezer and warm the action with a heat gun before assembly. You can't go wrong with this barrel at this price from Brownells.

Great barrel to lighten and increase accuracy of a 10/22! Yes, you have to fit it to the receiver.. that's a good thing, folks! Wrap a piece of medium emery cloth around the shank and twist the barrel to evenly remove material. Check often for a tight fit. No problem and a no-slop fit. Substantial accuracy improvement. 100% reliability with various ammo makes (so far). I'll be buying another one for another 10/22 I'm building up.

I installed this barrel, and zeroed my scope and at 50 yards. I shot the bulls-eye out if a target, just one big ragged hole. The barrel is super light weight and with the compensator it was surprisingly quiet.

I bought this to go on a customized ruger 10/22. In the end, this thing is sweet. Installation however, was a bit tougher than expected. I had a rough time getting the Ruger barrell out of my receiver, but that has nothing to do with this barrel. This barrel did however need to be sanded down to fit properly. The lug that sits in the recess in the receiver doesn't fit. I essentially had to sand off the finish to get a proper fit. Once fitted, this barrel is sweet. The finish looks good, but does not match exactly that of the 10/22 receiver. Once together however, you hardly notice the difference. The threads were nice and clean. The Tactical Solutions compensator screwed right on out of the box. All in all, I'm happy with this barrel. It looks good, and shoots darn straight. Just don't expect a quick drop in install.