GHOST - Ghost Rocket 3.5 Trigger Connector Gen 1-5

Used this part in 6-7 Glocks and always satisfied. This part with titanium safety plunger plus light trigger bar polish reduced rough 7 lbs pull to 3 lb 12 oz.

Yes fitting is required. Fitted as it should be it creates a much crisper feel to your Glock. I highly recommend it being fitted by a COMPETENT gunsmith. It's not hard to install but if you don't know what your doing you will cause yourself a lot of frustration.

It takes a few times of install, assemble, test, disassemble, file then try again. Once you get the travel set to where the cruciform releases the striker every time what an amazing upgrade! I have previously polished the oem trigger bar , safety plunger, and contact face of striker. While installing this I also did the ghost spring kit. 4lb striker 6lb trigger and reduced force safety plunger spring. Polish, springs, and connector took about $45 and 2 hours labor all together. Spending any money on anything else would be foolish in my mind. This is the only stuff I will ever put on anything I own. Required fitting is listed as a con. It is not a negative thing to have to put forth effort to make your stuff better and should be considered as a positive.

I purchased 4 of these and 3 triggers for install on 4 different Glocks. 3 Gen 3's and a Gen 4. It takes about 15 to 30 minutes to get it fit properly to each gun if you take your time. and can completely remove overtravel in the trigger after the break. I installed this with 3 different Apex Triggers. The best combination was with Trigger part number 100023505. It was a blue one with the narrow safety. The take up was nice and light with the pressure coming up just before the break. After the first round, the reset is nice and short with a nice smooth pull to re-fire. All of the Apex triggers had an extremely smooth pull with this connector. The Stock Trigger was certainly improved and lighter than stock but needed to be smoothed out in order to improve the feel. I recommend the Apex Trigger with the new trigger bar for the best overall improvement to the feel. If you get one of these you will need the Armorers Slide Cover Plate, 100001260, in order to release the trigger when doing the set up. you technically "Could" do it without it, but the cover plate is cheap enough. Just add it to the cart and save yourself the frustration!

when properly fit it will increase your accuracy with shorter trigger travel and lower trigger pull. required for fitting is the orange cap for the slide. This allows you to release the trigger bar from the striker when fitting. If the trigger is still spongy look for flex in the transfer bar. Add the heavy trigger reset spring for lighter pull and better reset.