CYLINDER & SLIDE - 1911 Low Mass Match Hammer Set 5pc

I purchased a hammer 40 Years ago it cracked brownells warrantee the hammer

All of the components necessary for a 4lb. Trigger pull in a 1911.

I have built dozens of custom 1911 and 2011 pistols, as well as "gutted" many and used this fire control set in place of the OEM parts. C&S is the only set I use for this need. I have installed them all at one time or another, but the consistency with C&S is 100%. Any of the C&S kits will work for your need. I sound like I work for them! ;) If I could give it 10 stars, I would.

This is truly a drop in trigger job. Ive purchased 3 sets so far. Two went into Kimbers and the last one I purchased went into a Springfield EMP4. All 3 pistols were under a 4lb pull with factory springs and zero creep. The EMP4 has a 3.25lb. pull weight. These hammer and sear sets are amazing.

I put this kit along with a Cylinder & Slide hammer strut into a Rock Island Armory Tac Ultra 45 acp. The stock trigger was heavy, had some grit and a little creep. The Low mass kit solved all those problems. I did have to file the safety and remove some material from the hammer strut to get the kit to fit, Bought a second kit for another RIA I have in 10mm. Not a big fan of speed of deliver with Brownells though. They are slower than most online retailers.