LISLE CORPORATION - SHOTGUN BARREL HONE

These are perfect for cleaning up a rusty or slightly pitted chamber in a shotgun.

I got my 870's chamber smoothed out with this hone and now feeding and extraction is much smoother. I also halve a lot less problems shooting Winchester 100 Round Value Packs through it now after honing my chamber. Great product!!

I bought this in conjunction with the extension for the purpose of cleaning up the bores on a muzzleloading shotgun.The product worked great and did a good job. My only issue with this was the shaft was too big to fit into the end of the extension.A few minutes with my Dremel tool and I was able to pare down the aluminum shaft enough that it would fit the extension right. All in all I was satisfied with it.

I purchased this hone, with an extra set of stones, to remove pitting from the barrel of an almost ninety year single-shot 12 gauge shotgun. The shotgun was left to me by an uncle, who had kept it by his kitchen door for over 60 years. He had also fired it, on occasions, well into his nineties. But, it was apparent he had stopped cleaning it properly at some point in his later years. It took some hours of careful honing, but I was able to remove the pitting and return the barrel to a safe operating condition using this hone. Since everything was so worn, and in such bad shape, and this was not an expensive antique, I returned the shotgun to it's original appearance and usefulness - the condition I remembered it being in as a youngster. I take pleasure in knowing my uncle would be pleased with the condition of his old shotgun as it is now. This inexpensive hone made the restoration possible without spending more than the shotgun was worth in dollars. The shotgun now sits unused, but the memories of my uncle have been preserved in it, and it sits proudly in my gun cabinet - ready for use if ever needed, and just the way I know my uncle would have wanted.