RCBS - Bullet Puller w/o Collet

You never know when you have to pull a bullet. This bullet puller gets the job done. I’m able to pull the bullet without any deformations to it and reuse it.

No complaints, and it's SO much faster and easier than those messy inertial pullers. Does it rotate in the press when you turn the collet clamp? Put a bit of lead shot under the brass set screw, turn it tight, and tighten the puller into your press a bit more. Does it scratch your bullets? Only if the collet is too tight or too lose--it made no marks on my 30 caliber round nose bullets. Too hard to tighten? Put a little grease on the collet and threads. Seriously, this tool works just as it should, every time.

Excellent Bullet Puller. Non destructive, Fast and neat powder handling. No mess.

PRO: If the right collet is used, it works excellent. I can only attest to 38, 9mm, and 45 acp. No more powder spills or pounding on the ground like the kinetic pullers. It is build solid. Con: you may have to have a single stage press to use it unless you take off a die from you progressive to use it.

Works great. Once it is adjusted properly, very simple to use. Using to pull loads that were too light and didnt cycle properly. Save those precious 9mm! Brownells was the only place that had the .35 caliber collet in stock.