Happy made in USA and the quality shows
Ive used this to reload 100 rounds of 50 BMG so far. Linkage to the ram and to the handle are fairly tight. (I recall trying an RCBS Rockchucker years ago when I suspect RCBS was outsourcing its manufacturing and the linkage was very sloppy. Same went for a powder dispenser which measured very inconsistently. Nice to see quality control come back being made in USA. I have an RCBS press I purchased in 1984 that is still going strong.). The dies work as expected. Interestingly, using Imperial Sizing Die Wax was not the way to go in sizing the 50. There was a lot of resistance in resizing. The RCBS lube was much smoother in reducing sizing resistance. I havent used the supplied trim die but once. I am using the LE Wilson trimmer instead. My only minor complaint is in tightening the shell holder to the ram. I used a crescent wrench, which gets just enough purchase on the lock ring. I would like to have seen a short flat wrench available to tighten the lock ring with more ease. You dont need to tighten the lock ring much. I am very happy with this press.
