10 Rnd clip for Remington 7400
Won't work, worthless.
Does not feed in rem 7400 30-06
Sharp edges that mark up casings, doesnt rotate bullet to center like original mags do, constant failure to feeds with destroyed unfired bullets. Rem discontinued their autoloading 30-06 for a reason.
Do not fit
I bought these for a Remington 742 in .308 and they do not fit at all without some work. They are 1mm longer than the factory mags and about .3 mm wider which is just enough to cause them to not insert. The welds holding the floorplate are spot welds and looks sloppy with gaps between the body and the floorplate. You will get dirt in the mag unless you stick/tig/mig weld them, do some grinding, and refinish. For a product needing to be precision made, these are anything but precision.
Will not feed a 30-06 Round
I bought three of these magazines for my Remington 750 Woodmaster in 30-06. The narrative clearly states this magazine will work in a 750 Woodmaster. All three magazines will not feed. The first round feeds correctly. All rounds jammed during the normal cycling process and I was using factory loads, not reloads. I then used the original 4 round magazine and everything fed and cycled correctly. I am very disappointed in this product and I will be returning them.
Trash
The bolt won't cycle if there's more than one round in the mag, won't take more than 5 rounds, the mag takes a lot of force to go into the well which means it doesn't fit.. Also, there's no bolt release on it. I don't know whether to return them or just throw them away because I know it's my civic duty.
Doesn't worn in Model 742
These mags don't load, seat & cause the bolt to jam in Remington Model 742. None of the 7400 series mags seem to fit, load or properly operate either. Keep looking for actual Remington 742 mags otherwise you're just waisting time & money.
7400 rifle
Bought this for a REM 7400 the clip holds the shell down to long and jams every time. The indents on the side of the clip that raise the bullet is to far forward about a 3/16 in. compared to the clip I use a 280. Might work with bullets that have a very short nose on them or other models.
Poor Quality Magazines
Recently bought two of these 10 round magazines for my 30-06. I first time I put the rounds into one of them,the bottom cap came off, the spring flew out and the rounds ended up on the turf. Was pretty embarrassed at the range..The other magazine that does work is exceptionally tight fitting and difficult to get out of the gun..Not happy at all about this purchase Tony Magazzi
will not chamber 3 rounds in a row.
I have cleaned my rifle, also cleaned both of my 4 and 10 round mags. My rifle shot fine with the 4 round mag, but it would not shoot 3 times in a row with the 10 round mag. It even broke to tip off of 1 of my Ballistic Tip bulletswith the 10 round mag in, the action feels slower like it is dragging. Putting both clips aft end towards each other you can see the original mag is a mil or 2 wider at the feed point. Perhaps thats the problem? Maybe it can be bent?
not again
bought 2 for 742 30-06, fowler poped out, no front tabs to hold fowler in, sides misscut, sides not bent in at a proper curve to hold rounds, not worth the postage to return to triple k
