Must have part!!
Measured before and after trigger pull in Glock 19. This part alone reduced trigger pull weight one full pound. Lighter spring, smoother part finish, surface hardness, excellent fit all help. This part, 3.5 Ghost connector, and light trigger bar polish reduced pull from 7 lbs to smooth 3 lb 12 oz. used this part in 6-7 Glocks and always happy.
Glock Safety Plunger
I think the plunger offers an upgrade in the performance of the pistol when combined with a new connector. The edges of the plunger are much smoother and stronger so you should experience a long service life. It certainly makes the feel of the trigger more crisp. It is a drop in item so no fitting or polishing is required.
Fantastic Product
I installed this safety plunger (and supplied spring) along with a 969-161-610 Reduced Power Striker Spring in my carry G19. Previously I had installed a 3.5 pound connector and NY1 spring to create a steady pressure trigger similar to a double action revolver. These two parts changed the trigger pull into a very smooth action and the pull weight dropped from just under 8 pounds to 6.5 pounds. It is hard to imagine the difference without actually experiencing it.
Glock Titanium safety plunger
If you have a glock, you need this!!! It makes the trigger feel more that of one on a double action pistol. I can now feel a sooth pre-travel, followed by a crisp action.
Improving perfection
I install this safety plunger as part of a personal trigger job on all my glocks. They work find and I have not had any problems with them.
Trigger Job
I use this product as part of a trigger job for all my Glocks. Easy installation, have had no problems, and is economical.
G 22
wonderful product. Use it with the 3.5 ghost connector and the trigger feels alot smoother. The oringal trigger weight is just fine but had to much creep and the break was not clean. With these two products the creep has almost been eliminated and is a smooth draw and a clean break. Would put these in any Glock.
model 30
fit perfect in the gun. much better than the factory plunger. trigger pull is much smoother. looks good also
Good addition to a reduced pull trigger.
I have fired 200+ rounds downrange on trigger job, which includes the L.S. titanium plunger. It ads to a smooth, more consistent, lightened trigger. It also complements the L.S. titanium striker. T.P.D.A.
Longevity issues
I wish it lasted a little longer. I wore this sucker out with just over 3,000 rounds down the pipe. When I first installed the Ti plunger its operation was smooth and silky, but with over 3,000 rounds through my Gen4 G22 with the Ti Safety Plunger installed, it was beginning to feel gritty and showing signs of wear, most notable is scoring of the cylinder edge that contacts the extractor. I like this product, but I had to pull it out of my weapon when I found metal shavings inside the plunger hole, striker pin channel and on the extractor. I run my weapon pretty hard and never experienced a malfunction or FTE, but I cannot continue to use this plunger in it's current condition. Hmmm.... I wonder if Brownells will replace it? Maybe I should give the sales team a call.
