XS SIGHT SYSTEMS - Winchester 94 Scout Mount

This mount is a Very GOOD" set up for this type rifle . The back of the Scope mount`s far enough forward so you can operate the hammer without the scope over the top of the hammer. The scope is far enough forward , where it won`t bust your eye from muzzel blast. it mount`s your scope Very low close to the barrel where it should be on this rifle. Mine is set up with a 2X7X28 MM scope , an Exlent Set Up on this 44 mag rifle for 100 too 200 yd. uses . The Con`s "... I Had to do a LOT" of grinding on the bottom of the mount with a Dremal tool to get the mount to fit right without Flexing when you tork the dang thing down , but FINELY" got it to fix Great" after about 3 hour`s work on it. That part NOT" , fun , but beside`s the extra work on the mount it`s self , it`s a Beautiful set up on the little 44 rifle and work`s Extreamley well with my scope set up. I Still give it 5 stars . My gun shoot`s Pretty Small Groups at 100 yds. now and 5 inch groups at 200 yds. I Love The XS Mount system on this rifle , It IS" , One Fine Set Up On the Rifle !

Simply perfect.

I have mounted these on rifles for use of scopes and red dot sights. The ease of use and balance to the weapon makes it very fast, handy, and accurate.

I put the scope mount on my Marlin 336BL. Yes, as other reviews state, it does require a degree of fitting. It even says that may be required in the instructions. In any event, I was able to mate the pillar block and the mount to the receiver in about 30-40 minutes. After that, the rest was simple to install with the supplied hardware. Looks good and is very solid at this point. In my opinion, I would rather fit the mount than it be oversize or out of spec in some other way to ensure it fits a variety of different guns without alteration...kind of like having it custom fit for my gun.

Comes with everything you'll need and then some. They include a hard plastic punch for removing the dovetail sight. Mine came out with only a few light taps. They also include about 10x more threadlock than you actually need, and more is most always better. Mounting process is very simple and good instructions are included. Installation took all of ~10 minutes for me with only a light sanding of the bottom of the pillar block to fit in the dovetail slot. Now the 1 star off things are small, but somewhat relevant. The etched lettering on the side is fairly blurry, and I don't like that they smacked the patent number right on the side and still blurry. Also, the bolts don't line up with each other at all when torqued. Again that's small and insignificant overall, but I feel it would look much better if the flat head slots lined up. Besides that it is completely solid, and very easy to install.