YANKEE HILL MACHINE CO., INC. - Mini Riser Assembly

I use a riser for my Eotech XPS3. This was the third mount I tried to raise the magnifier to work with it. The others didn't have enough room below the rail for the magnifier to grab on to. This one works great. Attaches tightly to my DD MK18 Rail.

Use them on flat top A.R., with how tall rings u might need 4 comfortable lines of sight and clear forward hand guards, especially if using large optical lens ,or adjustable optics, 4 clearance between scopes and barrels, with no interference. Quality products never have had a problem with any Yankee hill products, these are 1st. thing I look 4 if i need that little extra height or clearance, I wouldn't have as many sets if the one's I've purchased didn't work

I used a pair of these to go between a two piece mount and Weaver see-thru rings on my Rem. 742 so I could use a large objective 15 power scope and also be able to use the iron sights. According to my bore sighter this should be great. I can see these will have many uses.

I bought an eotech xps3-2 for an ar15 .308. Unfortunately, the addition of the quick detach lever assembly, the sight is about half an inch higher than the old design which pretty much made my back up sights useless. Rather than return it or strip the eotech off of my .223, I used these to raise my sights half an inch. While it probably negated any weight shed from the smaller eotech design, it does what I need it to. And while I really don't care much for how my rifle looks, these blend right into the build. They install in seconds and I could probably do it one handed, upside down in the dark. Very easy.

With most tube type red dot sights these risers lift the dot up enough to lie slightly above the line of the irons. With the mini dots all the rage, it takes two of these risers, one atop the other, to bring the tiny sight to the perfect height. The mini riser is very solid as to make my Bushnell mini dot feel like it's welded to the receiver.