EGW - Sight Mount For Vortex Razor Fits Springfield XD/XDM Black

Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions

• Remove the rear sight*
• Install the EGW Sight Mount in the dovetail
• Tighten set screw (if applicable)
• Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
• Apply blue Loctite to the provided mounting screws
• Torque mounting screws to 15in/lbs

The screws that are included with this mount require a 5/64'' allen wrench for installation.

This mount fits:

• All XD Models that are NOT the Optics Ready Model

This includes, but is not limited to:

• Springfield XD® MOD.2® – 3"" SUB-COMPACT MODEL
• Springfield XD® MOD.2® – 3.3"" SUB-COMPACT MODEL
• Springfield XD® MOD.2® – 4"" SERVICE MODEL
• Springfield XD® MOD.2® – 4"" SERVICE MODEL THREADED BARREL
• Springfield XD® MOD.2® – 5"" TACTICAL MODEL
• Springfield XD® 3"" SUB-COMPACT MODEL
• Springfield XD® 4"" SERVICE MODEL
• Springfield XD(M)® 3.8"" COMPACT MODEL
• Springfield XD(M)® 3.8"" MODEL
• Springfield XD(M)® 4.5"" MODEL
• Springfield XD(M)® 4.5"" THREADED BARREL MODEL
• Springfield XD-S® 3.3"" MODEL
• Springfield XD-E™ 3.3"" SINGLE STACK
• Springfield XD-E™ 3.8"" SINGLE STACK

Does not fit:

• Springfield XD(M)® 5.25"" COMPETITION SERIES MODEL
• Any Optics Ready Springfield XD