GHOST - Minus 3.5 Connector

Pre polished very nice. Big improvement!!!

installed in my model 22 which has a apex trigger. with a zev and lone wolf connector which are very similar in trigger pull having a 3-31/2 lb trigger pull. with the minus 3.5 connector went to 41/2 lbs. went back to lone wolf and got a 31/4 pull with some minor polishing. tried a few different ghost connectors but never liked them. this one continues like other ghost connectors.

Loose in the housing like its made of thinner metal. ive never had a problem with ghost before. This minus connector isnt even sold on the ghost inc website. I always use the ranger 4.5 and already ordered one. This is a waist of 10$

First, and biggest issue was that this connector does not fit securely/snuggly into the ejector housing. It was very loose and slid right out under its own weight. Sloppy fit has the potential to cause other issues with wear and reset in the ejector housing and trigger bar. The second issue was the finish. On the surface where the trigger bar butts against the connector there were several large scratches that I suspect would cause a gritty feeling in the trigger pull. The edges were jagged in a few spots which looks like it could be the spot where the connector was broken out of the mold or broken off the block it was machined from (dont know which method they use) either way, this piece was not given any final finishing care. I have used the Ghost Ranger 4.5 connector in two other guns with great results. So it could be that this one single connector is bad quality or this model isnt made to spec. Final thoughts: this connector is a waste of money. I would either go with the factory connectors or one of the Ghost Ranger connectors.