SMART LOCK TECHNOLOGY, INC. - XD EasyFit Mag Well, 9mm/.40 S&W

Ok, for a start. I wanted it for an XDM 5.25 9 mm. BUT It was Not an exact fit. I worked it with my tools and glue and made it work.

Does not fit as expected. Had to trim a lot and still does not fit well. There is a gap at the bottom. The holding screw only makes a hole on the frame. Bit disappointed indeed.

I bought this for my XD 40. It fits the hole at the bottom of the grip but does not take in the whole insert and it creates a gap I have to use a small mallet to push it. The stopper screw at the back of the magwell makes a hole in my grip. I have to put glue to hold the sides of the magwell because it creates a gap on the side. I have to put glue to in between the bottom part of the grip and the magwell to hold it in place because the screw was not able to hold the grip in place it slowly slips. I have to make some resizing of the insert of the magwell so that it will fit the bottom of the grip but despite all these it serves it purpose.

installed on my xd tac 9mm the tab on it didnt fit at all ended up removing it and using the screw drectly into my grip very flexable and thin felling. way better off getting a metal mag well.