Of all nature’s storms, none is more dangerous than a hurricane. These tropical storms strike the Atlantic and Gulf of Mexico coastal regions each year from June to November.
Wildfire! The word conjures up visions of Smokey the Bear, firefighters scrambling around the forest with chainsaws, specialized aircraft, huge plumes of flame, and the charred remains of mighty trees.
A hurricane, also known as a “tropical cyclone” or “typhoon,” is a severe, rotating tropical storm that produces heavy rains and cyclonic winds exceeding 75 miles (119 km) per hour.
A tornado, also known as a "twister" or a "cyclone," is a violent rotating column of air in the shape of a funnel that extends from the base of a thunderstorm to the ground.
Basic Application Instructions for New or Stripped Clean & Dry Wood
Instructions for Brownells Surface Hardening Compound
I recently purchased
a Remington 870
at a local gun show. It had been well maintained, but with
every gun that
sees a lot of use, there were some wear marks and
imperfections that detracted
from its appearance.
Dicro-Clean No. 909 is designed for use by the gunsmith to properly clean
firearms prior to the bluing or parkerizing operation. It may be used in any
welded steel tank, heated by gas burners, steam coils or electric heat element
This heavy duty, industrial quality tool is designed to quickly and easily
true the face of muslin or felt buffing wheels. The Wheel Rake can be used
either in the initial preparation of the wheel face prior to the application of
polish, or later to remove any imperfections or uneven worn areas.
Brownells Room Temperature Nickel Stripper is an immersion-process
chemical stripper developed to remove both electrolytic and electroless nickel
plating from steel, copper, and copper alloys. The process is safe, simple,
and requires no heat, agitation, or electrical hookups.
Coarse, matte finishes have become popular for tactical and utility
firearms because they require less attention to external wear and are fast
and easy to produce using high-pressure (100+ psi) abrasive blasting. The
combination of coarse grit and higher pressures requires increased protection
to prevent unwanted abrasive damage.
Prior to bluing or the application of a bake on coating, a steel surface must be properly prepared. In either case, at a minimum the work piece must be thoroughly and completely degreased.
Thank you for contacting our Chat Team! Please visit us again.
If you would like a copy of the chat transcript please click "Send Transcript" below.
Hello, to begin a chat session with a customer service representative, complete the fields below and click Chat