Takes The Pain Out Of Fitting The 2-Step Rivet
Two specially ground punches make fitting the 870 ejector spring
and housing onto Remingtons' unique 2-step rivet a snap! The
hole in the face of the #1 tool allows you to fasten the ejector
housing to the receiver with the lower portion of the rivet. The #2
tool is then used to secure the ejector spring within the ejector
housing with the upper portion of the rivet. Deluxe Kit
combines the above two punches with an ejector spring rivet
cutter that lets you take off just the peened area of the front rivet.
Often lets you re-peen the existing rivet.
Big Book Catalog, Issue:66, Page:492
Big Book Catalog, Issue:66, Page:494
New Product Supplement, Issue:524, Page:000
SPECS: Punches - Hardened steel, blue finish. 2
punches, each 3-½" (8.8cm) long. Rivet Cutter - Steel
shaft and hardened steel cutter. 2-½" (6.3cm) long, .31" (7.8mm)
shaft diameter, .143" (3.6mm) cutter diameter.