Fast, Accurate Choke Tube Installations Using Reamers From Dave Manson
A quick and easy method to install choke tubes using a lathe (can
be done by hand, however, a lathe gives superior results). Tap
and reamer are precision ground from high speed steel and use
the same interchangeable pilot bushings. Reamer has an
enhanced end relief that provides a faster cut. Pilot bushings are
available in diameter increments of .001", and are 2" long for
accurate bore alignment. Factory instructions are included.
Note: Read and understand the installation requirements
on page 62 before proceeding. For
best results, remove any existing choke with the Angle Blade
Expanding Choke Reamer prior to using the Loon Lake Choke
here for proper installation requirements.
Uses the same tap and bushings as Win-Choke, requires a different reamer to position threads in a different location. Barrels threaded to this system accept Rem-Choke-style and Remington factory tubes.
Big Book Catalog, Issue:65, Page:488
SPECS: 12 gauge only. .814"-32 tpi.