Use Sights, Ribs Or Bases As Their Own Drill Jig
3 special Center Punches with outside diameters (O.D.) that match
the clearance drill size of the most popular sight, rib and scope
base mounting screws. Ground, parallel-sided punches reach
through even the thickest handgun rib. Ends guess-work and hole
center-to-center spacing problems. To Use: Level gun in vise or
scope mounting jig, position and level sight, rib or base, and clamp
in place. Place correct size punch in hole and lightly tap with a
4-oz. hammer. Remove base; drill and tap first hole; re-install base
and check positioning. If everything is "square", re-clamp and
finish other holes.
Big Book Catalog, Issue:65, Page:443
Big Book Catalog, Issue:65, Page:473
SPECS: 2-¾" (7.0cm) long. ¼" (6.3cm) dia. knurled
handle. Hardened, tool steel. Set contains one of each size.