9mm Elite Tactical Magazine

Comments about WILSON COMBAT 1911 9MM 10RD ETM MAGAZINE:

Bought four mags for IDPA . Had a problem with the front lip of the mag body hitting on the bottom of a ramped barrel.(kimber target 2) Not sure if this was a Wilson problem or a Kimber barrel problem? Cut off 16th of a inch from the front of the mag body and they work fine. Have used wilson mags for years in my 45's without problems.

Comments about WILSON COMBAT 1911 9MM 10RD ETM MAGAZINE:

At last a dedicated ten round 9 mm magazine. perfect for IPSC here in Australia where we have ten round and 9 mm/38 calibre restrictions.

Comments about WILSON COMBAT 1911 9MM 10RD ETM MAGAZINE:

Works great in all my Kimbers and is all i recomend.

Comments about WILSON COMBAT 1911 9MM 10RD ETM MAGAZINE:

Bought three of these to replace the Kimber factory mags which were subpar. These are easy to load, function 100% and are very well made!

Comments about WILSON COMBAT 1911 9MM 10RD ETM MAGAZINE:

A little bit tight on the tenth round, but other than that, they work great. I'm hoping it'll losen up a bit over time.

Comments about WILSON COMBAT 1911 9MM 10RD ETM MAGAZINE:

Shoot IPSC Limited 10 with a Springfield 1911 in 9mm. Bought 2 of these mags, the follower in one went out after about 40 rounds. Called Wilson, sent a replacement, it too only lasted about 50 rounds. The other mag works fine so far. Had a g/smith look at them and measured each, they are the same, just a bad plastic follower. Wilson Rep. said plastic is easier and it desn't bind like a metal follower and is self-lubricating. Plastic seems not uniform around the edges and the high heat here in NV causes it to expand. Expanded and part of problem was the follower was catching on the mag catch slot as rounds pressed down into the mag. Nice mag body, but follower needs big improvement. Metal would be better; could never depend on this mag in a carry gun.