Hundreds of abrasive "balls" mounted on a flexible shaft - the
fastest, easiest way we've come across to clean and polish older
barrels or put a mirror polish in new ones. For used barrels, the
Medium-Coarse hone, followed by the Fine, removes rough and
tight spots and brings the bore to a bright finish that you can see
and feel . . . just run a patch through it before and after; the
difference is amazing! We found too, that we could feel tight spots
during honing and spend extra time on them until they were
evened out. On new barrels, the Fine hone by itself will bring the
factory finish up to a beautiful, mirror-bright finish that's a real
customer pleaser. Easy to use: chuck in a variable speed electric
drill; wet the hone with Flex Hone® oil; start
the drill and insert the hone into the barrel from the breech end (if
possible). As it cuts, a slurry of abrasive and oil develops to help
speed the cutting action. Flex Hone® available
(shown below)
in sets and individual hones for 10, 12, 16 and 20 gauge barrels
as well as .410 bore. Also, special-sized hones for 10, 12, 16, 20
gauge chambers and .410 bore. Instructions walk you through the
steps for a perfect job. (You MUST use Flex
Hone® oil - all other oils will destroy the
abrasive "balls" and void our guarantee!) 750 RPM MAX.
Avoid excess pressure.
SPECS: Flex Hone®
for Barrels; 10, 12, 16, 20 ga., .410 bore. 33" (83.8cm)
long in Med.-Coarse grit (red tip) or Fine grit (light blue tip).
Flex Hone® for
Chambers; 10, 12, 16, 20 ga., .410 bore 12" (6.5cm) long,
fine grit (light blue only). Set includes Med.-Coarse &
Fine barrel hones, Chamber hone & 1 qt. Flex
Hone® oil, for 1 ga.
Catalog page 480