Quick-release lever-lock system clamps solidly to flattop rail and will not work loose even under heavy recoil—the more force acting on the lever, the tighter it locks. Depress the release tab to swing the lever open, and the mount easily lifts off the rifle. Adjustable with a flat head screwdriver or even a coin for an ultra-secure, no-slip fit on almost any Picatinny or Weaver-style rail, including over- or under-sized commercial rails. Lever may be configured to lock to the front or the rear to suit the operator’s preference. Large locking bar on the side of the mount engages the maximum amount of rail area, while the crossbolt and two integral locking lugs ensure rock-solid engagement of rail slots to prevent movement under recoil. Five heavy duty steel hex head screws (three on top, two on bottom) clamp the vertically split ring halves together. Cutouts in the ring sides and in the base reduce weight without sacrificing strength. AD-68 Aimpoint Mount is designed for Aimpoint optics or similar aiming devices requiring a single, 30mm ring, including the Comp C3 and M2/ML2/M3/ML3 series. Available in four configurations to suit a variety of mounting needs. Standard co-witnesses “iron” sights near the center of the optic when mounted on an AR-15/M16/M4 with standard-height mil-spec sights. Low positions the scope as close as possible to the top of the receiver. High positions the backup sight picture in the lower 1/3 of the optic viewing area. Cantilever provides same co-witness elevation as High mount and positions the Aimpoint 1½" forward to provide room for rear-mounted night-vision device or Aimpoint 3X Magnifier.
SPECS:
6061 T6 aluminum, hardcoat anodized, matte black. Height measured from top of rail to bottom of scope body. Standard - .940” high. Low - .520” high. High – 1.120” high. Cantilever - 1.120” high.
Catalog page 81